Lennox furnace filter size and location
Lennox filters usually sit in a return air grille or in a slot or rack on the side or bottom of the furnace. Some Lennox systems use a thicker media cabinet instead.
- Lennox says filters are typically in the return air vent, which may be on the ceiling, on a wall or on the side of the furnace or air handler. Some sit inside the unit.
- Some Lennox gas furnaces, such as the EL296DFE, have no built-in filter rack. The filter is installed outside the furnace, and Lennox recommends checking it monthly.
- Lennox's Elite series manual sets the filter size by cabinet width and return location. 17½-inch cabinets take a 16x25x1. 21-inch cabinets take a 16x25x1 on a side return or a 20x25x1 on a bottom return. 24½-inch cabinets take two 16x25x1 filters on a side return or one 24x25x1 on a bottom return.
- To find your size, Lennox says to read the size printed on the old filter's frame. If there's no filter, measure the opening.
- Install the new filter with the arrows on the frame pointing toward the furnace or air handler.
- Lennox Healthy Climate media cabinets use expandable filters, such as part X8309 (HCXF20-10), sold as 16x25x5. These aren't standard flat filters.
The quickest answer is always the filter you have now. Read the three numbers on its frame and pick that size below.